How To Use The Stone Cutting Wire Saw Machine

Preparation :
Adjust the device: Make sure the device is stable, connect the power supply, air pipe, etc., and click to enter the operation interface.
Install the wire saw: adjust the pressure according to the wire diameter, install the upper line wheel and tighten the screws, and fix the diamond wire to the specified position.
Installation Samples :
Sample fixation: Place the sample on the sample stage and fix it in an appropriate manner.
Position adjustment: Make sure the sample is in the right cutting position by adjusting tools such as micrometers.
Cutting operation :
Parameter Setting: Adjust the weight stack position as needed to change the cutting speed.
Start Cutting: Open the water valve, click the cutting run button, and start the cutting process.
Observation and adjustment: During the cutting process, it is necessary to closely observe the operating status of the equipment and the cutting effect, and adjust the parameters in time.
Wrap up & clean up :
Stop cutting: After the cutting is completed, stop the device in time.
Clean up the site: Clean up the equipment and work site from debris and debris to keep it tidy.
‌